HP 7/16 TO 7/16 FITTING

Contact Us

Subacqua
Spain

Description:

Extension piece for high pressure ports HP 7/16, which facilitates the placement of wireless pressure transmitters in the first stage, since in many cases, the transmitter due to its width, interferes with any of the hoses.

Male 7/16 to female 7/16, approximate length 2.5 cm


SBRC0022

Data sheet

SPARES & ACCESSORIES
SPARES & ACCESSORIES FOR REGULATORS

Specific References

16 other products in the same category:

ICE CONVERSION KIT FOR TIFON REGULATOR

Kit cold/contaminated waters for Subaqua Tifon regulator. Converts a high-quality regulator, as is the typhoon, in one of supreme quality by adding the second membrane that makes the first stage completely sealed and valid for diving under the ice and even in contaminated water.

FIN CLIP HOLDER

Carabiner clip with nylon strap to hold fins to the diving equipment. Very handy if you dive from the ground and have to walk to reach the entry point leaving your hands free for support if necessary. Available in three colors: yellow, blue and red

BAUDRIER WEIGHT SYSTEM 7 KG

Baudrier weight system harness, consisting of three weighted pieces for a total weight of 7 kg.This kind of weight system, commonly used in professional and commercial diving, is ideal for all divers who need a large amount of weight, especially if diving with dry suit, because it allows for weight distribution along the shoulders and it is much more convenient than carrying a lot of weight at the waist.It includes reinforced nylon straps with plastic buckles, which form a fully adjustable harness.Three weights in a triangular back formation and two on the side.

ECO SUB WEIGHT BAG 1.5 KG

1.5 kg weight bag. This is the most comfortable diving weight system available and is easily placed in pockets or on your BCD. Thanks to antioxidant filler metals which replace lead as the weighted material, these bags are completely eco-friendly and will not harm or damage the marine environment. For the lasting durability of this product, the manufacturer recommends rinsing in fresh water after each salt water immersion to prevent corrosion and to increase the life of the protective mesh.

MARKER SHAFT STEEL

35 cm stainless steel shaft, very practical to mark objects or animals while diving. Incorporates a carabiner with a ring, all in stainless steel, easily attached to the BCD. Can be used as a support point for divers. Can also be used as a tank banger for underwater communication if necessary.