CHARGE VALVE FOR INFLATOR

Load valve for inflation systems and BC hoses. It acts as the wheel valve allowing air to pass in one direction when actuated

Contact Us

Subacqua
Spain

Description:

Load valve for inflation systems and BC hoses. It acts as the wheel valve allowing air to pass in one direction when actuated.

You must have a special tool for removal and / or installation.

Overall length: 16 mm

Diameter in the thread area: 5mm

SBBCY17

Data sheet

SPARES & ACCESSORIES
SPARES & ACCESSORIES FOR BCD
SPARES & ACCESSORIES
MAINTENANCE

Specific References

16 other products in the same category:

EXTENSIBLE CLIP

Extensible clip with swivel snap hook and stainless steel ring. On one end includes a steel key ring in order to set out and choke; the other includes a plastic carabiner to hold to a BD ring or another part of the diving gear.

ICE CONVERSION KIT FOR TIFON REGULATOR

Kit cold/contaminated waters for Subaqua Tifon regulator. Converts a high-quality regulator, as is the typhoon, in one of supreme quality by adding the second membrane that makes the first stage completely sealed and valid for diving under the ice and even in contaminated water.

LIFT BAG (Various Sizes)

Lift bag open type manufactured in high strength PVC with high frequency heat sealed seams. Slings are braided nylon and polypropylene are attached to the lifting surface via semicircular stainless steel rings by four points.

ECO SUB WEIGHT BAG 2 KG

2 kg weight bag. This is the most comfortable diving weight system available and is easily placed in pockets or on your BCD. Thanks to antioxidant filler metals which replace lead as the weighted material, these bags are completely eco-friendly and will not harm or damage the marine environment. For the lasting durability of this product, the manufacturer recommends rinsing in fresh water after each salt water immersion to prevent corrosion and to increase the life of the protective mesh.